• Configuration and setting memory over com port or paddle - view
• Memory message: 1816 characters non-volatile memory. 4 memory pages, 6 memory with 75 characters (24 memory message) Plus 16 characters for call sign
• Speed range 25 to 250 LPM (5 to 50 WPM) adjustable with potentiometer
• Iambic mode A or B
• Serial number counter with programmable length and zero/nine keying (09 or TN)
• Insert call sign and serial number in memory message with embedded command
• Programmable inter-letter spacing, 2 to 9 dit
• Automatic letterspace mode
• Beacon mode with programmable interval 1 to 99 sec, measured from begining or between message. Any memory or all memory may be set as beacon memory
• Adjustable Sidetone frequency 500 to 990 Hz
• Weight dit/pause 20 to 80%
• Swap paddle (left dah, right dit)
• Programable turning on/off sidetone or keying out
• Keying out: mosfet, transistor (positive) or reed-relay (positive or negative)
• Build receive practice with monitoring on PC
• Only four push-button for command mod and memory call. Without command like "press and hold"
• Operating voltage: 4.5 to 5.5 V or 7 to 15 V (seting by jumper)
• 20 one letter easy to use commands
• LED diode for mode signalisation (command mod, shift, beacon or tune)
• Simple upgrade new software version in microcontroler

User manual
Construction manual with shematic and pcb

Both document in zip

Hyper Terminal configuration prewiev

Programmed PIC microcontroller (16F876A): 25 EUR + 5 EUR shipping/handling
(Cijena za 9A radio-amatere je 70 kn + postarina)

Kit is not available jet.

Order by e-mail and send cash, check or money order by mail
E-mail for order:
Address:
Milivoj Bartos, Nehruov trg 5, 10020 ZAGREB, Croatia, Europe